Water is very important for cooling the house. Excessive humidity makes cooling more difficult. In the dry season, however, humidity is an effective tool for cooling the room. Swamp air coolers, or evaporative coolers, are cooling devices that use humidity to lower room temperature in dry climates. They work well as a complement to central air conditioning systems, but they can only work in small dwellings. The unit can reduce your electric bills by reducing the amount of time that the air conditioner runs. Swamp air coolers can only perform this task if they run efficiently. You can make your swamp cooler more efficient than it is now.
1. Measure the room so that you have the proper swamp cooler for the size of your room. Measure the length and width of the room. Multiply those numbers together to get the square footage. Multiply the result times the height of the ceiling to get the cubic feet. Buy another swamp air cooler that can cool a room of similar size if needed.
An improperly sized air cooler can cost you more in energy bills each year. According to the California Energy Commission’s Consumer Energy Center, you find the correct evaporative cooler by measuring the square feet of the cubic feet room and dividing< /a> by two. Pool coolers give an estimate of the amount of cubic feet they can cool. Match your event to find an estimate in the cooler location for the correct size. For example, a 10,000 square foot room requires a 5,000 CFM swamp cooler. CFM means cubic feet per minute, the amount of space that can be evaporatively cooled. You can find the cubic feet of your room by multiplying the square feet by the ceiling height.
2. Install a thermostat on the cooler to control the amount of time the engine runs. The thermostat will turn on the cooler when the room is cold enough. Follow the instructions that come with the thermostat for installation.
3. Look at the air cooler. Vacuum any dust from the vents and wipe away any debris. Soak the dry pads inside the unit in water and adjust the pump so that the pads are always wetted at the right time. Refer to the swamp air cooler manual for details. The U.S. Department of Energy recommends that you change or clean the pads in your swamp cooler once a month during the hottest months. This time it collects mineral structure from water faster. You can usually clean the pads with soap and water. To replace someone who cannot be cleaned.
4. That in the colder marsh of Thrace, when the middle of the air system begins. Running two systems at the same time only adds unnecessary energy costs to your bill. The thermostat should turn cooler when the room is freezing. But it is possible to turn the unit from moment to central-air-conditioner”>central-air-conditioner”>trat, so that the air is still to be heated
5. Test the air pressure in the room. The pump only cools effectively when it enters and leaves the room at the same time. As cold air is created by the cooler swamp, it is necessary to leave the air current. You can test the air flow in the room by turning on the cooler. If he closes the door of his room slowly.
Notes:
http://www.energysavers.gov/your_home/space_heating_cooling/index.cfm/mytopic=12360
http://www.consumerenergycenter.org/home/heating_cooling/evaporative.html
http://www.srpnet.com/energy/evap.aspx#efficiency
Report:
- www.energysavers.gov/your_home/space_heating_cooling/ index.cfm/ mytopic=1236
- www.consumerenergycenter.org/home/heating_cooling/evaporative.html< /a>
- www.srpnet.com/energy/evap.aspx#efficiency< /a>< /li>
