Wiring the bell actually requires two jobs to complete the wiring. Chima portion may have a bell. This circuit is usually 110/120 volt. The wires to the rods receive power from a transformer inside the toothed box to convert them to a low voltage level. Yes, wiring a doorbell chime into your home’s electrical power means that the switch or switch on the switch is tightening the wiring coming from the chime.
Begins the wiring process by determining where to place the wires inside your home.
Most of the doors are located in the central area of the house so that they can be easily heard throughout the space. This can be in the hall or on the wall of a room within easy hearing distance of the rest of the house. Sometimes multiple chimes are installed in various locations throughout a large residence, but more often this type of intercom system is handled as a necessity.
For an existing doorbell wire inside the house, look for an ungrounded circuit that runs close to the location of the unit.
Tap on this wire after cutting the power to it and run the wires to the doorbell location. If this is not possible, you will need to open your electrical panel and add a circuit. If they are not open to the new environment, you may want to call an electrician to add the board to you if you lack the skill or experience to do so. The power coming into your electrical panel is enough to stop your heart if you move wrong. Leave it to the developer.
You can cut the power to the whole house and add a circuit breaker if space allows.
A white wire to the ground panel on both sides or on the bottom of your box. The black wire is inserted into the breaker and secured. The bare wire will touch the ground like a wire. After the wire outside the file and run to your site. This may require trips to your home, base, or crawl space of your home.
Make a small hole in the wall near the middle where the bell is attached.
Bring the wire through this hole. You can turn off the power to your home, but leave the transgressor that feeds this circuit. Inspect the new bell to make sure the hole lines up with where the end unit wires exit. Make any necessary adjustments to the opening to pass the wires to your film.
Low voltage wires run from this hole to the outside button locations.
This part of the job can get a bit tricky if you are installing a doorbell for the first time in an existing home. . Follow the same path through the wall that you used to hit at full power. After you enter the area above or below the wall, run the wires where they will enter outside your wall. Make the outside where the wires will come out. A hole in the tray at the top or bottom wall. Slide the wire through the hole until it reaches the exit outside.
Sometimes, you may choose to do open house insides.
By cutting a clean hole in the drywall inside the house, you can have more space to get the wires. inserted and installed neatly. The problem is that you have to patch the hole and return the area when you’re done. It can do this faster than fighting with a small hole outside.
When you have finished running the wires, it is time to connect the box and the rods.
Attach the wires to the back of the switch or switch from the outside. Using the screws provided, attach the switch to the sides of your house so that the hole behind it and the wires are hidden. Follow the instructions that come with the new doorbell to wire the switch and power to the wiring unit.
All the wires are connected, screw the box to the wall.
After attaching the bell to the wall, replace the screen in front. Turn the power on the bell. Get out and try the unit. When it echoes or cymbals, the job is done.
