After years of use, the surface of the swimming pool roof is starting to show its age. Harsh weather, acid washes, and just general wear and tear have worn down the surface until it needs repair and resurfacing. While it’s best to hire professionals to do this job for you, there can be thousands of dollars in savings if you’re brave enough to try to do it yourself.
First estimate how much repair and resurfacing is needed.
If the tank doesn’t have large cracks and chips in the plaster, you can do minor repair work and avoid the hassle of resurfacing the whole thing. Any cracks and chips should be repaired first. This will give you a chance to decide if major work will need to be done to replace your tank.
Vacate the area and allow to dry before proceeding.
During this process, the surface of the lake will be ready to receive products that fill cracks and chips. It will also give you more time to scan for any damage around the sides and bottom of the tank. Carefully time this process when there is no excess ground water pressure or you will damage your tank by freezing it, or lift out of the pelvis.
Use the correct products to fill cracks and chips.
A variety of commercial products are available for this purpose. You should take a sample of the plaster from your pool to the pool center to ensure that you buy products< /a> compatible with your current pool surface. When you have the proper material, fill all visible cracks and chips to level the finish.
If the cracks and chips are small, you can use the volume on the material to smooth the resurrection.
Some of these products are roughly equivalent to interior painting of your pool. They may require multiple coats for signing and a new goal. When the paint roller will be used use for a new surface, the effort and time to complete the work should be reasonable. The drying time of these products is also quite fast.
After the previous repair work, you may find that a full resurfacing job is necessary.
If you can afford it, you might want to consider a professional role at this point. But if you want to insist on doing it yourself, you will find that it takes a long hard time to finish the nice smooth work. Don’t think about rushing this part of the process, or you’ll end up with a low-quality job.
Marcite and gunite are two of the most popular products for pool surfaces.
You will need specialized equipment to spray these surfaces into your tank. Make sure you get the right type of protective clothing and breathing devices can be used by certain products to protect you. You may find it necessary to go down the finish line to the last scoop to make it smooth. Some products require a finish board to be applied with a sprayer or roller on the end. It is best to try to stick with the same or similar product for the new surface that you had on the previous one.
