Almost everyone takes their houseplants extra late in the spring or early summer. They are left outside until the weather cools down. Their bottom plates are removed to drain the water to keep the mosquito population from exploding. You remove the dew or hose plants to remove dust, dirt, and pests.
Unless you have a lot of time, it is always better to dry the area under the pots after the water is drained through the soil, but few people, including me, have a lot of time. At the end of the season, when you move the pots, you may find water spots on your concrete floor. A power washers will reduce cleaning time to remove stains, but many people don’t have one. those But you can wash off those stains using the right kitchen supplies found. Not only save money, but it will be more earth friendly.
Remove stains
After removing the pots, wash the area with water and a liquid brush. Sometimes you need to wash off all the hard water stains with a little elbow grease. If you still cannot remove the stain to your satisfaction, proceed to the next section.
Use LiquidDish Soap
Wet some liquid soap on the spot or stain and dry clean over the wet area. Leave the soap to rest for 10 minutes. Meanwhile, put a pot on the stove and bring a pot of water to boil. Dip a stiff brush into hot and target the spot. Be careful not to burn yourself with hot. This step can be repeated several times to remove stubborn stains . If you still have a concrete spot, proceed to the next section. Please note that in the following sections, do not allow the cleaning mixture to come into contact with plants, weeds, grass, or any growing vegetation.
Pour in the vinegar
Place the vinegar directly on the stain and allow it to penetrate for an hour or two. You don’t want the sun to dry the vinegar, so add more vinegar over the stain as needed. Do not throw concrete vinegar if vegetation is growing, because vinegar kills plants, herbs and plants. . stain remover with a brush You can repeat this step several times. If it still doesn’t leave your spot, proceed to the next section.
Use oxygenated white and Hot water
Mix the oxygenated bleach and warm water together in a bucket. The ratio is one part water to two parts bleach. Pour this solution over the stain and allow it to penetrate the stain for five to ten minutes. Take a hard silk and dip it in a bucket of warm water. Clear the area and repeat the procedure if necessary. If water stains still remain, there is another solution to use. This damage should be used more carefully on the ground.
Use Trisodium Phosphate and Water
Mix 1 cup of trisodium phosphate with 1 gallon of water. Use 1 gallon of water for 1 cup of trisodium phosphate. Pour the solution over the stain, allowing it to remain undisturbed for 15 to 20 minutes. Dip a stiff bristle brush in a bucket of warm water and wipe the stain. You may repeat this step several times before the stain is gone.
Admonitions
If using bleach or trisodium phosphate, keep kids safe and care from the area. Use rubber gloves when scrubbing stains to protect your hands.
This should remove water stains or make them less noticeable. If it still bothers you, then you can hire a professional cleaner to do the job for you. You can discuss the problem with them for additional suggestions on using a cleaner to do the job.
Resources:
Office of Magic: Painful hard water spots
Housekeeping Channel: Remove Stains from Stone, Tile and Concrete
Do it yourself: Concrete stain Remove
