When you make a hat, you will have to choose how well you are going to do it. If you are going to get a night job, you have to use construction paper. If you’re going to get a job in a few days, you’re going to feel like you’re at least some kind of movie or whatever material. This is the longest any run of the mill, fly by night costume maker parent’s work is going to be, If you are going to create an actual hat and create your entire hat, where you have a solid hat, maybe even sequins. I can’t tell you how to do it. I’m sorry.
The first part of making the hat is the same material you use. It is important to note that this part is accurate. It is convenient to wear a hat. take the hat from them and put it on the paper. The circumference of the hat. Take special care not to bend or move it. That hat is now for the charms of the man’s head, so we would like it to remain exactly as it is. Now draw another circle around the circle you just drew, that is 2 inches larger. The easiest way to do this is to make 5 points where they are 2 inches away from the first circle. Take a circle and scan the circle around which hits all those points. Once the circle is cut out, cut out the outer circle. Place the outer circle around the head of the person who will put it on, so that it wraps around the whole head. If it’s slightly too big, that’s okay. Now you have the circumference of his head.
Drag this same size circle on the selected material. Now draw another circle about 6-8 inches larger than the first circle. Cut the larger circle, and he will cut the smaller circle. Now you have a lip the size of your hat, you’re only 1/2 done. If you are using cardboard, now would be a good time to lacquer the top. If you lacquer it, it will do so that it will not fall off, and it will be as straight as it can be.
Rolled up about three sheets of construction paper, or one material. You attach these rolls to yourself so that you have a nice tall column. You can make this cylinder as long as you want, but the average size of the stove top hat was about a foot;
if you used construction paper, add two 1-footers to the inside of the pipe. You can attach this with glue or paste. When the glue hardens, it will stand firm and straight. Put a lot of glue on the top of your lip, and put all the glue on top. Allow to stand for about 5 min. Invert the whole thing, and place a small spike of glue around the inner lip. Then, in about 12 different places, which they apply from the inside to the top, they get it completely. Turn again and add another bead of glue around the top. When it dries clear, it will not be seen. Cut a circle size head and tape and glue.
If you use a device, the device must stay on its own. However, they run two to three large wires, such as the wire of the coat hanger, the tube and about 3 inches from the bottom. Place the top of the stirrer in the workspace. Hold the lip all the way down and place it over the top. Take the thread and bend it into the lip. Bend as close as possible to the lip, and the wire lies back at the top. Place a bead of fabric glue over the seam line, and outside where the top is sticking.
After everything dries, you have a hat.
