If your wireless router comes with multiple instructions, follow this simple how-to guide and you’ll have your wireless router up and running in minutes. Make sure all directions are followed carefully to avoid unnecessary issues.
First, close or turn off your computer and remove the wired network (the one that looks like a big phone line) that you are connected to.
Next, plug in all the cables routed as described in the included instructions. If you want to connect one or more of your computers directly to your router with an Ethernet connection, you may do so now (you must connect at least one computer to the Internet connection).
Now connect your cable or DSL modem to the router using a wired connection (usually the router has one of the plugs on the back labeled as ” Internet” to plug in this cable.
At this point, turn on your cable or DSL modem, then after about 20-30 seconds, turn on your router. and then turn the computer into a repeater with the copper wire/ethene. You need to use this computer wirelessly to set up any router settings before using wireless. .
Now you need to configure your computer to obtain an IP address automatically (DHCP). You will usually have instructions for doing this in your travel guide, but here are the basic steps;
First, open your Control Panel and right-click on “Network” or right-click on “My Local Network” and select Properties.
Now right click on your link (there can be several, make sure you get one thing by choosing the one that is actually connected, the others will show disconnected) and select properties again.
Now you need to double-click on the Protocol (TCP/IP) box in the window.
Now make sure “Own the site automatically” is selected.
You can click on both windows to close them and save your new information
Now you will configure your router with the computer that is connected to it using the connected connection. Open Internet Explorer, Google Chrome, Mozilla Firefox, or another browser of your choice and in the address field type the IP address of the router ( (usually 192.168.1.1 or try 10.1.10.1 if that doesn’t seem to work). Just fill in the basic information for your router, you don’t need to do much here unless you want to set up a static IP for things like remote connections or servers, which most home users never bother with.
You can also take this opportunity to set up your own encryption security to keep your neighbors out of the loop. To set up encryption, usually the “Wireless Security” tab in the router’s setup. Select the encryption type you prefer, 128 bit is generally recommended. Once you’ve done this, you’ll only need to give each computer or wireless device (printers, iPods, etc) the code you’ve generated or the one you want.
After you have completed all the previous steps, you just need to make sure that all your computers are in the same workgroup – this will make it easier for you to share files and printers. If you’re setting up computers for the first time, most of them will probably pick the same group name by default, although Windows 7 uses a new feature called Homegroups that makes this step even easier. Just click on each computer in “My Computer” and select properties, then check the group name. If any of them are different, just switch them to find other computers on your network. While you’re there, make sure all computers have a unique name, otherwise we’ll get an error saying “Copy name is in decorated
Now you can connect all your computers with the wireless capability of your router without problems. Most routers tend to have a few ports on the back so you can hook up a few computers with wired connections if you want.
Remember that everyone’s journey is a little different. These general instructions should give you some guidance if you’re having trouble setting up your route or just running around to see how complicated it is. Good bye!
Report:
- www.microsoft.com/athome/organization/wirelesssetup.aspx< /a>< /li>
- www.ehow.com/how_2211658_set-up-wireless-router.html< /a>
- www.buzzle.com/articles/wireless-router- setup.html< /a>
