A toilet problem can be a real pain for anyone to know. Fortunately, determining that the toilet is not working properly is not a pain. Here are a few tips for troubleshooting problems with the toilet.
How the toilet works
There are basically two parts to the toilet – tank and the bowl. The bowl is the end of the business – so to speak – and sits directly on the floor. the tank sits above the bowl and holds the water.
The whole contraption is quite simple. The flushing valve in the tank opens and allows the water to rush into the bowl due to gravity. This flow of water pushes the waste into the bowl through the toilet trap and into the sewer lines. There is a secret faucet in the water supply line that allows the tanks and bowls to be filled with water after each flush. .
Common problems with the toilet
Minor problems with the toilet can be fixed by a plumber but the first step is to find out what the problem is. Most homeowners run into a leaking toilet bowl, a toilet that doesn’t normally flush – usually because of some type of waste or a toilet that is constantly running.
Leaking toilet bowl
Correcting a portasse toilet bowl requires a lot of effort, but it can be done. A leaking bowl most often occurs due to a wax ring that is not properly sealed. This ring of wax is placed under the toilet and above the sewer line. It can be damaged over time. This damage usually occurs due to loose toilet and lightly used rocks.
The portasse is usually marked around the base of the toilet. If you notice that this area is constantly wet, has a strong urine smell, or is discolored, it may be a false ring of wax. your guilty It is quite easy to replace the wax ring.
To replace the wax ring, you need to buy the wax ring ahead of time. Turn off the water supply to the toilet then unhook the water supply line. Next loosen the barriers holding the toilet in place.
Once the toilet bolts are released, they can be pulled straight out and fall out of the sewer. While wearing gloves, remove and discard the old wax from the ring. The new ring can now be stored in a secret location. Push the toilet firmly to seal the wax ring correctly. Tighten the locks – enough to move the toilet from the driveway. Be careful not to tighten the locks.
The bathroom doesn’t want to flush properly
How frustrating is it to push the toilet handle and nothing happens? This usually happens because of a problem with the floating chain and flapper valve. Sometimes the chain will become unhooked from the valve or spring mechanism. When the handle is released – then the valve does not open.
This is easy to fix and can be done by removing the lid from the tank and the chain to reach the float or valve. A broken chain will need to be replaced and will require a local hardware store.
A toilet that runs continuously
If you use your toilet and it continues to run, the water spout is also running. This is a common problem and can be fixed with a trip to your hardware store. A toilet that continues to run after flushing is most often due to a valve that does not close properly. The valve will continue to pump water from the tank into the bowl and allow the tank to fill. Over time the valve can become bent and worn which causes it to not seal properly.
Turn off the water supply, flush the toilet to empty the tank then remove the valve. Take it to your local hardware store to get it replaced and then go back home and install a new valve. A valve replacement costs less than five dollars.
Use precautions and all professional safety
With any type of lead project, you should always exercise caution, wear gloves and call a professional if the job you’re trying to do turns out to be more than you can handle.
Source:
http://www.doityourself.com/stry/repairtoiletproblems
